/

 

ISSN 0536-1028 (Print)              ISSN 2686-9853 (Online)  
УДК 622.831 DOI: 10.21440/0536-1028-2021-6-5-12

Download

For citation: Liskovets A. S., Tatsienko V. P., Gogolin V. A. The effect of contact grouting on support load. Izvestiya vysshikh uchebnykh zavedenii. Gornyi zhurnal = News of the Higher Institutions. Mining Journal. 2021; 6: 5–12. DOI: 10.21440/0536-1028-2021-6-5-12

Introduction. The paper analyzes contemporary methods of frame support design in permanent workings and reveals that contact grouting has received little attention. Contact grouting makes the tight contact between the hardened cement grout and the surrounding rock possible, whereas it is impossible when applying concrete lagging. The paper employs analytical method of arch support, grouting layer, and the surrounding rock calculation considering their softening. Analytical formulae determining support load has been obtained. The formulae take into account strain and strength characteristics of the surrounding rock, hardened cement grout, and support. Support load was calculated under various values of the grouting layer thickness and linear strain modulus and the depth of mining. The dependencies between the support load and the indicated parameters have been obtained, which makes it possible to select the cement grout composition for various mining and geological conditions.
Research objective is to determine the effect produced by grouting layer thickness and strain characteristics on arch support load value in order to check its strength in various mining and geological conditions.
Methods of research are built upon the physically based analytical methods of geomechanics to solve the problem of interaction between the support, grouting layer, and surrounding rock mass.
Results. The results of arched support load calculation are presented for various values of grouting layer thickness, its strain characteristics, and depth of mining.
Conclusions. The presence of the grouting layer in the void behind the support has a significant effect on the methods of arch support design. The developed methods take account of the fact that a layer of soft rock develops in the rock mass between the grouting layer and undisturbed rock. When the rock is being broken, its volume in this layer increases, which, in its turn, results in support load transfer growth through the grouting layer. It has been determined that the increase in the hardened cement grout strain and grouting layer thickness reduces support load.

Keywords: arch support; grouting layer; support load.

 

REFERENCES

  1. Liskovets A. S., Tatsienko V. P. Analysis of support and tamping methods of the behind-anchoring space of mine workings and methods for calculating the interaction of the support with the rock massif. Tekhnika i tekhnologiia gornogo dela = Journal of Mining and Geotechnical Engineering. 2021; 1(12): 27–52. (In Russ.) Available from: doi: 10.26730/2618-7434-2021-1-27-52
  2. Bulychev N. S. Mechanics of underground structures. Moscow: Nedra Publishing; 1982. (In Russ.)
  3. Sammal A. S., Voronina I. Iu., Shelepov N. V. Mathematical modelling the interaction of parallel non-circular underwater tunnel multilayer linings with the technologically heterogeneous rock mass. Izvestiia Tulskogo Gosudarstvennogo Universiteta. Nauki o Zemle = Proceedings of the Tula State University. Earth Sciences. 2016; 3: 154–163. (In Russ.)
  4. Sammal A. S., Sergeev S. V., Antsiferov S. V., Deev P. V. Estimating concrete shaft lining application field in zones of tectonic disturbance. Izvestiia Tulskogo Gosudarstvennogo Universiteta. Nauki o Zemle = Proceedings of the Tula State University. Earth Sciences. 2018; 4: 317–326. (In Russ.)
  5. Antsiferov S. V., Fotieva N. N., Bulychev N. S., Gribanov V. B. About the calculation of tunnel lining, constructed in a soil massif, subject to preparatory strenghtening. Izvestiia Tulskogo Gosudarstvennogo Universiteta. Nauki o Zemle = Proceedings of the Tula State University. Earth Sciences. 2015; 3: 98–107. (In Russ.)
  6. Golovin K. A., Kovalev R. A., Kopylov A. B. Calculation of lining which interacting with layer of widened rock. Izvestiia Tulskogo Gosudarstvennogo Universiteta. Nauki o Zemle = Proceedings of the Tula State University. Earth Sciences. 2016; 4: 174–178. (In Russ.)
  7. Deev P. V., Sammal A. S., Antsiferov S. V., Shelepov N. V. Influencing technological gap value by stress state of tunnel linings. Izvestiia Tulskogo Gosudarstvennogo Universiteta. Nauki o Zemle = Proceedings of the Tula State University. Earth Sciences. 2018; 4: 287–293. (In Russ.)
  8. He S., Lai J., Zhong Y., Wang K. Damage behaviors, prediction methods and prevention methods of rockburst in 13 deep traffic tunnels in China. Engineering Failure Analysis. 2021; 121: 105178. Available from: doi: 10.1016/j.engfailanal.2020.105178
  9. Szurgacz D., Brodny J. Adapting the powered roof support to diverse mining and geological conditions. Energies. 2020; 13(2): 405. Available from: doi: 10.3390/en13020405
  10. Malkowski P., Ostrowski L., Brodny J. Analysis of Young's modulus for Carboniferrous sedimentary rocks and its relationship with uniaxial compressive strength using different methods of modulus determination. Journal of Sustainable Mining. 2018; 17(3): 145–157.
  11. Yu Y., Bai J., Wang X., Zhang L. Control of the surrounding rock of a goaf-side entry driving heading mining face. Sustainability. 2020; 12(7): 2623. Available from: doi: 10.3390/su12072623
  12. Chen Z., He P., Yan D. M., et al. Upper-bound limit analysis of tunnel face stability under advanced support. Yantu Lixue. 2019; 40(6): 2154–2162. Available from: doi: 10.16285/j.rsm.2018.1903
  13. Vokhmin S. A., Kurchin G. S., Maiorov E. S., Kirsanov A. K., Kostylev S. S. An overview of deep horizons excavation lining technologies at Oktyabrsky deposit. Izvestiya vysshikh uchebnykh zavedenii.Gornyi zhurnal = News of the Higher Institutions. Mining Journal. 2019; 7: 45–52. (In Russ.) Available from: doi: 10.21440/0536-1028-2019-7-45-52
  14. Tatsienko V. P., Gogolin V. A., Ermakova I. A., Lesin Iu. V., Liskovets A. S. Calculation of the support with filling of the space behind the support. Vestnik Kuzbasskogo Gosudarstvennogo Tekhnicheskogo Universiteta = Bulletin of the Kuzbass State Technical University. 2019; 3: 75–81. (In Russ.)
  15. Liskovets A. S., Tatsienko V. P., Gogolin V. A., Ermakova I. A. Engineering method for calculating pressure at the support and displacement of crown with filling of the space behind the support. Vestnik Kuzbasskogo Gosudarstvennogo Tekhnicheskogo Universiteta = Bulletin of the Kuzbass State Technical University. 2020; 2: 97–102. (In Russ.)
  16. Shtumpf G. G., Ryzhkov Iu. A., Shalamanov V. A., Petrov A. I. Physical and mechanical properties of rock and coal of the Kuznetsk Basin. Moscow: Nedra Publishing; 1994. (In Russ.)

 

Language

E-mail

This email address is being protected from spambots. You need JavaScript enabled to view it.

Мы индексируемся в: